Sound Generator for Alarm


This is sound generator circuit.You can use this circuit for your alarm circuits.Here I have used common IC 4011.This circuit gives about 10W through a 8 ohm speaker.This circuit can be control (on and off) with sw1.






Note

# Use 12V smooth power supply for this

# Build this on a PCB

#If you are unable to find IC 4011 you can use Ic MC14011 or TC14011

Comments

Post a Comment

Popular posts from this blog

Low-Side MOSFET Drive Circuits and Techniques - 7 Practical Circuits

Image
In many circuits, it is necessary to use MOSFETs for switching. In many cases, the MOSFET drive signals are generated by microcontrollers. In other cases, they are generated by ICs – PWM controllers, timers or any IC in fact. However, MOSFETs cannot always just be connected to the drive signal and be expected to work properly. Due to the construction of the MOSFET, driving it is not the simplest of tasks, especially for beginners. There are many users who regularly ask for help on MOSFET drive related issues or problems on different blogs, websites and forums. So, here I will show some MOSFET drive techniques/methods for MOSFETs configured as low-side switches. Before I head on to MOSFET drive, let me just tell you what a low-side switch is, in case you don't know. When the MOSFET (that you're using as a switch) sinks current, it is a low-side switch. The load will be between the drain and +V supply. The source will be connected to ground. Gate will be driven with respect to gr...
Read more

Using the TLP250 Isolated MOSFET Driver - Explanation and Example Circuits

Image
I’ve already shown how to drive an N-channel MOSFET (or even an IGBT) in both high-side and low-side configurations in a multitude of ways. I’ve also explained the principles of driving the MOSFETs in these configurations. The dedicated drivers I’ve shown so far are the TC427 and IR2110. Some people have requested me to write up on MOSFET drive using the very popular TLP250. And I’ll explain that here. The TLP250, like any driver, has an input stage, an output stage and a power supply connection. What’s special about the TLP250 is that the TLP250 is an optically isolated driver, meaning that the input and output are “optically isolated”. The isolation is optical – the input stage is an LED and the receiving output stage is light sensitive (think “photodetector”). Before delving any further, let’s look at the pin configuration and the truth table. Fig. 1 - TLP250 Pin Configuration Fig. 2 - TLP250 Truth Table Fig. 1 clearly shows the input LED side and the receiving photodetector as well...
Read more

Simple MW Transmitter Circuit Diagram

Image
Today I'm going to give you a simple MW Transmitter.This transmitter can be operated with 9 v power supply.Here we have used common transistor BF494B.Here we have used MW antenna coil you can use the 8 ohm speaker to speak that means here the speaker does the work of the mic.To get the maximum result build this on a pcb and don't supply power without connecting the antenna.             Note:   Don't missuse this circuit            you can send signals up to 500M
Read more